Gunco Forums banner

Press fitting question.

426 Views 4 Replies 4 Participants Last post by  alfajim
I want to press and pin a muzzle brake on to a bare barrel. The barrel diameter is .580 inch. I plan to cool it down in a bucket of ice and heat up the muzzle brake.
What does the I.D. of the muzzle brake need to be? I do not have a shop press. But I do have a rubber mallet. :)

Any help appreciated.
1 - 1 of 5 Posts
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.