Gunco Forums banner

1 - 6 of 6 Posts

·
Administrator
Joined
·
7,143 Posts
Discussion Starter · #1 ·
I noticed homier is selling a 6 ton A frame style press for $39.99. http://www.homier.com/default.asp And do a search for 6 ton shop press. Is this press to small for most AK builds? It definitely is a good price - but I remember most use a 12 or 20 ton press. I currently have access to a press, so am not really in the market for one - but figured for the price this would be a good one if it would work for doing AK builds.
 

·
Premium Member
Joined
·
6,900 Posts
Mike,

It would probably work OK for the riveting, but it would not be any good for barrel work, it doesn't have the height required.
 

·
Administrator
Joined
·
7,143 Posts
Discussion Starter · #3 ·
Max, thanks for the answer - I got to realizing shipping is on top of the price and if I went for a press it would be more cost effective to get one from the local harbor freight store.
 

·
Registered
Joined
·
2,071 Posts
They come around all the time. Just get on their mailing list and they let you know when they come near you. I think your right about the rivets. Mine seem to smash farily easily with the 20 ton. I couldn't find the picture of the 6 ton. When I push out my barrels, the barrel is face down with the trunnion up. I could easily do it with a press that had just 6 in. to work with. When I reinstall mine, I hammer it in. If I could get 6 in. of clearance I think it is doable to remove barrel. Just depends on if you are using special jigs like Xebec's. I think the barrel is reversed with it and you would need a lot of clearance. Can't beat the price though.
 

·
Registered
Joined
·
825 Posts
When Homier rolls into town, they sell the 20 ton press for $99.00. I have one and it is a real nice press.
 

·
Registered
Joined
·
2,071 Posts
Everytime I show up to see if they have one, they are already sold out. If you do try to get one when they come in town, go early.
 
1 - 6 of 6 Posts
Top