Gunco Forums banner
21 - 33 of 33 Posts

·
Registered
Joined
·
125 Posts
I agree rob, but the point I was getting at was this:
The average person could at one time buy tools, and kits to build several AKs for the same money of a mid to high end factory AK. THOSE days are gone forever (barring a change in current laws).
 

·
Registered
Joined
·
136 Posts
How do you get in touch with Curtis ? I really would like to know what jigs and fixtures are available, Just got into my first build . Tried to make my own receiver forming jig, but after that i am lost. Will post pics asap
 

·
Registered
Joined
·
136 Posts
Thanks Chief Just ordered a few jigs and odd parts, Web site was a dream to use. Made ordering so easy I spent $100.00 more than i planned. This building of AK's is going to be expensive, i can tell. Bought a H/F drill press and its great for 1/8" and under but 1/2 inch in 1/2 inch steel choaked it. Went to Ebay and found a 400 lbs Wilton Drill Press for $150.00 (but 250.00 for shipping) so to make the freight cost reasonable i bought another 400lbs of stuff. After years of just collecting guns my new hobby will be to try and build a few.

Today i spent a lot of time getting to know my garage floor. If the door was open a passer by could have mistaken me for a muslim (no offense intended) for the amount of time i was on my knees with a hammer in my hand. You guys convinced me to pull tghe BBl. on my AMD Kit and drill out the rivets. Getting the BBl. pin out wasn't that bad with the BFH. Next to buy is a 20 ton press.
 

·
Where's my lathe?
Joined
·
1,105 Posts
ummm, yea. Me too.
In reply to the baby stuff, I hit the wrong button I guess.
 
21 - 33 of 33 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top