Gunco Forums banner
1 - 1 of 1 Posts

· Registered
73 Posts
Discussion Starter · #1 ·
OK I got my rivets in from Kvar and the rivet tools and video from Joeken ( Imagine angels singing) will be here tomorow and Ill be ready to rivet together my first two builds. But just one thing. The tapered rivets (bulg) that came in the rivet set are too big in diameter for the holes in the front trunnion and the tapco flat. The flat bottom rivets fit it just fine. The holes in the flat and trunnion measure .160 and the tapered rivets shafts are .173. Have any of you run into this before and if so whats the fix. Or will the video explane it all. Thanks TREY
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.