Gunco Forums banner

1 - 18 of 18 Posts

·
Registered
Joined
·
2,325 Posts
Discussion Starter · #1 ·
19" barrel. Hogue rubberized pistol grip.
MD Arms 20 rd. drum, Ace folding stock.
G2 trigger (double hook), using the original hammer.
Made my own trigger guard out of heavy gauge stainless.
Test drive tomorrow.



 

·
Premium Member
Joined
·
6,900 Posts
Looks nice.
I'm just curious as to why you chose to use the factory hammer instead of the one that came with the G2?
 

·
Registered
Joined
·
2,325 Posts
Discussion Starter · #3 ·
The stock hammer was already fitted for width to fit beside the
bolt hold open plate, which hinges on the hammer's axis pin.
It was just an expedient thing to do.
 

·
Registered
Joined
·
14,032 Posts
Looks good.

I want to hear more on the Hogue pistol grip, I'm thinking of getting one but have'nt heard anything from someone who actually has one.
 

·
Registered
Joined
·
2,325 Posts
Discussion Starter · #8 · (Edited)
Late development.
Had another day off, and was looking at Quad-rails for my Saiga.
$200 is not my idea of being able to use a vertical fore-grip.

After many brain farts. I went to my local auto parts store and
bought an 18" section of 1-3/4" exhaust pipe.

I studied the plastic stock forward lower, and put the pipe in my
large vise and mashed it to match contours of stock item.
Installed a picatinny rail on the bottom, plug welded it in.
Mimicked the Cetme hole pattern on the lower.
Welded on a G3 front and rear sight.
Hot damn! I feel more satisfied now.

[The Hogue Grip is a winner, a slight cushion effect, very ergonomic]






 

·
Registered
Joined
·
14,032 Posts
Thanks for the info on the grip.

And DAMN you did get a lot done!!! Looks even better

Favor asking time. :D
Can you try to get a pic of the sight picture, close to how it would look when you look through those sights?
 

·
Registered
Joined
·
149 Posts
I love your mighty fine creation, be sure to tell us your test fire results. That shotgun looks like loads of fun Cheers IRONMULE:notworthy
 

·
Premium Member
Joined
·
6,900 Posts
The stock hammer was already fitted for width to fit beside the
bolt hold open plate, which hinges on the hammer's axis pin.
It was just an expedient thing to do.
Besides having to remove about .050 from the right hand pin boss for the BHO you need to re-contour the front profile, but both are very simple operations. I did both in just a couple of minutes on the bench grinder. The reason I brought it up was because I too have heard of problems with mixing the two.

Nice job on the forearm.
 

·
Registered
Joined
·
2,325 Posts
Discussion Starter · #14 ·
Here she is with the Tapco trigger and Saiga hammer.
I may need to put on some weight.
10 round dumpl

[video=youtube;pxHWEajeokU]http://www.youtube.com/watch?v=pxHWEajeokU]YouTube - Saiga 12 rapid fire[/video]
 

·
Registered
Joined
·
2,325 Posts
Discussion Starter · #17 ·
I have added the Miss. Arms fake suppressor as of late.

 

·
Registered
Joined
·
445 Posts
That is one nice cannon! Good Job!
I need to get one of those.
 
1 - 18 of 18 Posts
Top