[shadow29483]

Would anyone happen to have a pic of the selector switch install.
Mine's kicking my ass, In between the trigger assembly and the catch won't latch. It's about 1/8" From the safety catch.
Thanks guys,
Shadow

 

[ak'sr4me]

It sounds like you have a location problem with the holes for the selector lever and the trigger axis pin. Too much distance so to say. I have had this same problem on two of my builds. What I have done to correct this problem is to build up the some metal by welding the selecter lever where it is suppose to contact the trigger. Just build up that area of the selector lever and then file it or grind it until it firmly contacts the trigger. I could post a picture of one of my selector levers that I have done this to, if you don't understand what I am trying to explain if you would like. ak'sr4me

 

[tac-40]

Some of the FCG's require you to install the Selector lever then rotate it counter clockwise (backwards) until it goes into the proper position. This is because the selector tab will not clear the disconnector and the disconnector will not rotate out of the way far enough. Just pull the lever portion of the selector away from the receiver while rotating so you can clear the rivets/bolts in the rear trunion.

 

[shadow29483]

I kind of get the idea, Please send me a pic.
Thanks....Shadow

 

[ak'sr4me]

Here is a pic of one of the selector levers I had to lengthen.

 

[shadow29483]

Ok, now I understand.
Thanks...Shadow