Gunco Forums banner

solving the GM spill problem: a different approach

439 Views 4 Replies 5 Participants Last post by  pirate56
Since capping appears unlikely, pressures high, answer is simple: multiple wells, as many as necessary, many multiple rigs drilling, and preps to contain the high natural gas and oil. Maybe Iran is not necessary at all? Is that bad news?

Call this "operation wedding ring" well known fact she'll stop putting out soon as the "ring" is in place, LOL,

think of it as a serial polygamous muslim, 4 wives, many times as it takes.

Ok, it's a gusher, extreme, but solution is NOT to cap it, but harness it. Fuel for our refineries, cars, homes.

worlds largest rig ? E maine, getting work done, wonder what the next assignment is?

Stop using the bad chem dispersants, also, were bad history alaska spill.
1 - 5 of 5 Posts
HMMMM never seen a ring plug a hole LOL lots of cheating wives out there.
I say use a tactical nuke. Placed correctly it would fuse the pipe and or collapse the well. I'ts not as radical as it sounds. A modern tactical nuke would leave far less radiation than the huge dirty post WWII nukes and at 5000 feet it would not even be measurable above the surface. All it takes is to drill a shallow well next to it and set it off. This thing could be shut off by the end of the week. It would be by far less damaging then letting this thing spew for the next 6 months.
I say shove Obama into the end of the pipe. Even if it doesn't plug the leak a benefit will still be gained.
I say shove Obama into the end of the pipe. Even if it doesn't plug the leak a benefit will still be gained.
with over 40 million gallons of oil floating around I guess a couple of hundred pounds of extra shit in the water won't hurt anything!!

base on the estimate of a few weeks ago of 40 million gallons discharged, that is enough to fill a tank 10 feet high, 10 feet wide and over 11 miles long.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top