Gunco Forums banner
1 - 14 of 14 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
This is a dynamite forum.Been checking it out for a while.Everyone seems up and active and willing to help!Sooo.I need some help.All over the forums jigs for this, jigs for that.I have a press just need to know where to buy and how much.Got several builds on the table and am itchin to get busy.AMD 65.Mac-90mutt.polytec mutt.had the last 2 mutts for a while and tapco was good to me!Arsenal USA supplying recievers and some compliance parts.sept.13 awb die and be cursed never to rise again in any shape or form. Appreciate any and all help please...fl.latvian......GOD GRANTS LIBERTY TO THOSE ONLY WILLING TO DEFEND IT...
 

·
Registered
Joined
·
3,421 Posts
fl.latvian,
If you decide to build a flat Jig, I'd be happy to help you out. The link that Cephus post was my first jig. I made a second version that is easier to build and works better.
 

·
Gunco Samurai
Joined
·
3,340 Posts
Bluejack said:
you maybe need these too
Ahhhhh, the triple crown of the home Kalashnikov builder.
 

·
Premium Member
Joined
·
6,900 Posts
I may end up with a TG rivet jig available.
I have not yet received payment for one of the jigs from the last batch.

If I don't hear from the guy soon, it's yours.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #9 ·
Thankyou for all your replies.The flat bending jig looks easy enough,it's riveting on the front trunnion I'm haveing a hard time with anyone know about that? These are my first builds so I'm getting type3 prebent,hardend.No problem with the barrel pins or barrel removal,got a press just don't know how to get those little suckers pressed back in without damageing the reciever?sorry..there from arsenal USA 1.6mm.
 

·
Premium Member
Joined
·
6,900 Posts
You need Plinkers jig for that. (The one on the far left in Bluejacks pic)

Do you have a mill to do the trunnions, or are you sending them to Arsenal and have them mill them for you?
 

·
Gunco Samurai
Joined
·
3,340 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #12 ·
7.62x39 said:
You need Plinkers jig for that. (The one on the far left in Bluejacks pic)

Do you have a mill to do the trunnions, or are you sending them to Arsenal and have them mill them for you?
Don't have a mill.Gonna wait and see just how much narrowing is required.Should have them in about a week and a half.Probably get them done local if necessary.Building larger shop which WILL be equipped.Read a thread somewhere where they did it with a grinder!!??
 
1 - 14 of 14 Posts
Top