Gunco Forums banner
Cancel

Tapco Ubend em receiver? Heat treated?

642 Views 2 Replies 2 Participants Last post by  Gun-nut, 
yosuthnmasa
I'm thinking about picking up a few of these. After bending do they need to be heat treated? What would this entail? I used an ACE blank and didn't heat treat it afte I was finished. Am I missing something here. How does the ACE thickness compare to the Tapco flat?
Reply
Save
Like
1 - 2 of 3 Posts
yosuthnmasa
Are the Tapco flats decent?

555th, what flats have you been using for your jig. Maybe we need to see if we can get a group buy going on these.
Reply
Save
Like
1 - 2 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Gunco Forums
A forum community dedicated to AK-47 and AR-15 firearm owners and enthusiasts. Come join the discussion about optics, hunting, gunsmithing, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
Off Topic Lounge AK-47 Discussion Forum AK BIY forum General Firearms Discussion Jokes and Humor
Top