Gunco Forums banner

Tapco Ubend em receiver? Heat treated?

638 Views 2 Replies 2 Participants Last post by  Gun-nut
I'm thinking about picking up a few of these. After bending do they need to be heat treated? What would this entail? I used an ACE blank and didn't heat treat it afte I was finished. Am I missing something here. How does the ACE thickness compare to the Tapco flat?
1 - 1 of 3 Posts
Here's my opinion on flats...stay away from them! I've tried them and they're just a waste of money!

Just my 2 cents worth!
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.