Gunco Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter · #1 ·
I recently built a bulgie 74 on an OOW receiver. I am having trouble with it feeding from bulgie mags. It feeds from bakelite mags just fine. I read on another site that the safety stop needs to be thinned so it will allow the rear of the mag to sit up higher in the rifle. I think this would solve me problem because if you pull the bulgie mags to the rear of the rifle it feeds fine.
What I need to know is what is the best way to thin the safety stop and how much to thin it? Thanks allot. Ark
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top