Gunco Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
12,413 Posts
Discussion Starter · #1 ·
I always tell people when I've had sucess with certain products and my cars are no different.

Early this week I installed Bosch +4 plugs, Accel cap&rotor, Accel wires, and Accel 48k volt coil on the 5.0L in my 93 Ford truck.

Big difference in performance. The idle is smoth, throttle response awesome, and it revs great. Hopefully with the extra juice I'll get better fuel mileage too. (Nothing aweome, but 2 mpg extra would be good)
 

·
Registered
Joined
·
138 Posts
I need to do the same to my truck. My mechanic was in shock when he saw that I still had the factory wiring in my 92 ford!
 

·
Registered
Joined
·
109 Posts
I'm sure those mods should provide you an extra mile or three per gallon Sang Run. My old, tired 300 six is in desperate need of such maintenance/upgrades.Between busy and lazy she just hasn't gotten the attention she's been begging for. (I wouldn't be so lazy if I weren't so darned busy!) I'm lucky to get 15mpg right now and I should be able to do a bit better with a good '**** tune' (quoting ZZ Top...) Hehe, I've been hauling some borderline loads, last night's was downright illegal and the first car I passed was one of Ohio's finest, sure glad it was a 'she' 'cause I'm pretty sure a 'he' would have yanked me to the side of the road and ticketed me. (with all due respect I had my 4 ways on and traveled at 35mph, sure wish I'd have had my slow moving vehicle triangle with me though)

Any thoughts on a 3/4 ton set of springs or ?

I owe you a PM, I'll have to go through to your last one. Seems everytime I get one on this forum board I'm asked if I'd like to have it open in a new window and after clicking "yes", it doesn't?? Just me a a board glitch? :confused:
 
1 - 3 of 3 Posts
Top