Gunco Forums banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
6,900 Posts
Discussion Starter #1
Who else here has one of E&D's version 1 laser cut flats?

The ones without the LH selector hole and the front cut incorrectly.

The problem with the front is that it was cut squared to the bottom instead of the top.
After welding I squared the front with the top, tapering the cut from the bottom to the top, removing 0 material at the top.
The problem is that now the receiver is almost .125 too short in the OAL.

I contacted E&D, (who had admitted to the problem on the other board) about a replacement, I never even received a reply.

How many others here, are stuck with one of these paper weights?
 

·
Registered
Joined
·
1,856 Posts
7.62x39......

Maybe you had the wrong email (majorwest at charter.net). I think that's the correct email. I remember them saying something about those who had the earlier flats could get them replaced.

When I purchased mine they were the new and improved flat. Hope you get some sort of response from them.
 

·
Administrator
Joined
·
7,143 Posts
i have two of the early u bend em's and if I could get the one I haven't messed with replaced that would be great. Is that the correct email address? (guess it is time to find the paypal receipt, lol).
 
1 - 3 of 3 Posts
Top