Gunco Forums banner

Ultimate Bending Jig

530 Views 7 Replies 4 Participants Last post by  BamaSam
I have eliminated the need for a bottle jack or any type of press. Nice crisp inside corners and on top rails also. Currently calculating production costs. These will be affordable and fairly priced. Since there isn't a need for a press does this make it preferable over any other jig?

Will work on any receiver flat.
1 - 2 of 8 Posts
Sounds like a plan BamaSam. I'm sure there are many that would like one of these.
Joeken? I've got some better ideas if you've contemplated this route.
1 - 2 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.