Gunco Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
I just put together an I/O Romanian under folder on an OOW receiver. Everything went slick and quick. Now I can't get the grip screw bushing down into the hole. The rear trunion might be too far forward to allow the bushing to clear the internal piece with the locking fingers; the right stock arm binds up on the head of the selector lever. So, now how do I get the out the pin that goes through the locking piece and the plunger button? Drill a hole in the bottom of the receiver to drift the pin out through? Everything else is good, tight & solid.
 

·
Visiting MOD
Joined
·
2,141 Posts
Yep, drill a hole.
All factory folders had a hole.
Got a question.
Why can't you put the bushing in from the bottom?
 

·
Registered
Joined
·
73 Posts
I drilled a hole in mine. I woulnt have known to do that unless I had seen it on the leftover part of the reciever from the original rifle.
 

·
Registered
Joined
·
158 Posts
bullet175 said:
I drilled a hole in mine. I woulnt have known to do that unless I had seen it on the leftover part of the reciever from the original rifle.
Could I get a pic of that?

I'm going to be adding a Romanian underfolder to a SAR. Newbie here, so anything I can learn in advance will help!
 

·
Registered
Joined
·
13 Posts
Discussion Starter · #5 ·
Thanks!

Drilled the hole, removed pin, removed folding parts; inserted bushing, attached the grip and then reassembled the folder. The hole is hidden under the pistol grip.

Bushing does not fit in from the bottom. I guess you could call it a grip screw too.

 
1 - 5 of 5 Posts
Top