Gunco Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
182 Posts
Discussion Starter · #1 ·
I'm putting together a bend up lazer cut receiver . I have already bent the top rails and would like to bolt or weld (havent decided which yet) the lower rails in before bending the bottom corners up. I've heard about using a drill bit to space the top and bottom rails, if so what size?...Thanks for any info.
 

·
Registered
Joined
·
681 Posts
I think a letter "c" drill. My memory is somewhat foggy, but I think I remember Sang or 7.62X39 posting that somewhere here.
 

·
Registered
Joined
·
1,856 Posts

·
Registered
Joined
·
72 Posts
I hope you play nice with your build when you get it done Rev Jim Jones. That Kool-Aid party ended very, very ugly. :bolt:
 
1 - 6 of 6 Posts
Top