Gunco Forums banner

Where to engrave pistol AK receiver?

323 Views 1 Reply 2 Participants Last post by  sniper69
Planning to put out a pistol AK stripped reciever. As a custom engraver, I can place the info any where on the receiver.

Any suggestions?

Also, I will be able to have custom serial numbers and "extras" like the USMC globe and anchor etc. The best info is that since I am the engraver, I can turn these very quickly!

thanks in advance.

Tom Sawyer Mfg
Woodbury, MN
07 FFL / 02 SOT
1 - 1 of 2 Posts
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.