Where to engrave pistol AK receiver?

323 Views 1 Reply 2 Participants Last post by sniper69, Sep 24, 2004

likemopar

Discussion Starter · Sep 24, 2004

Planning to put out a pistol AK stripped reciever. As a custom engraver, I can place the info any where on the receiver.

Any suggestions?

Also, I will be able to have custom serial numbers and "extras" like the USMC globe and anchor etc. The best info is that since I am the engraver, I can turn these very quickly!

thanks in advance.

Steve
Tom Sawyer Mfg
Woodbury, MN
07 FFL / 02 SOT

Save

1 - 1 of 2 Posts

sniper69

· #2 · Sep 24, 2004

I would suggest on the bottom in front of the magwell. Just my opinion of course.

Save

1 - 1 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.