Gunco Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Hello...first time builder and looking for advice on which reciever to start with!I see that there are the preformed and you drill the holes and fit the trunions ...and there are the different kinds of flat predrilled type that need to be bent...and theres the weld type and one that is laser precut and you weld on the lines...I have a pmkms kit..of course would like the least complicated way of doing a reciever...any suggestions?? :confused:
 

·
Registered
Joined
·
4,077 Posts
first build why not think about a reciever all bent with the holes allready in it??? then next time it is a lot easyer and you have one to compare to :)
 
1 - 3 of 3 Posts
Top