Gunco Forums banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
1,290 Posts
Discussion Starter · #1 ·
I am attempting to fit the CSS internal receiver block to my S12. I have cut off the tang on the rear trunion and have attempted to install the internal receiver block . However, when i attempt to mount the receiver block in the holes for the former original FCG, there is about a 1/16 gap between the rear of the receiver and the receiver block. Any one else have this problem? I am wondering if I have to egg out the holes in the receiver to make it fit flush? Any one have any thoughts on this?
 

·
Registered
Joined
·
14,032 Posts
You might have to egg the holes a little, 1/16" isn't much.
Is the gap on the bottom or is it a forward/backward type thing? If it's the bottom will it come back when you tighten the top screw?
Never messed with one so I'm guessing
 

·
Registered
Joined
·
789 Posts
this is common, at least on the 4 ive done. i did egg the holes just a bit. the screw heads will cover the holes so it will not look unsightly.
 

·
Premium Member
Joined
·
1,290 Posts
Discussion Starter · #5 ·
that is what ended up doing; egging the holes that is. I tighted down the screws real tight with some red lock tight. Now i just need to decide what stock Iam going to place on it
 
1 - 6 of 6 Posts
Top