Gunco Forums banner

1 - 7 of 7 Posts

·
Premium Member
Joined
·
1,290 Posts
Discussion Starter · #1 ·
I am looking for someone to move the trigger guard to its orginal position on my Saiga 12, anyone know who can do this work in a reasonable amount of time?
 

·
Premium Member
Joined
·
1,290 Posts
Discussion Starter · #5 ·
I was a little concerned about the remaining FCG holes, Coils gave me some ideas, including welding up the holes, but regarding welding the holes, I only have a Home Depot Lincoln Weld Pac MIG machine and not sure if it will be neat enough.
 

·
Registered
Joined
·
1,492 Posts
should work great... Flux or gas? gas is better but flux will work.

You can also get those plastic buttons that go in the holes.
Pat
 

·
Registered
Joined
·
14,032 Posts
Here's what those plastic plugs look like, don't buy them there, they can be found cheaper locally
TRIGGER GROUP HOLE PLUGS FOR SAIGA CONVERSIONS

If your comfortable using your welder, it should work, just do one hole at a time and let it cool before doing the next one.
For clean up use a file or a flap wheel in an angle grinder.
 
1 - 7 of 7 Posts
Top